Product Description |
PA66 20G0-200S is an unreinforced, high tough polyamide 66 for injection molding. |
General |
Form Resin Pellets |
|
Feature Good Thermal High Impact Abrasion Resistant |
Good Electrical Properties Outdoor |
Physical Nominal Value Test Method |
Density, dry 1.07 g/cm³ ISO 1183 |
Dry: Molding Shrinkage(4 mm) 1.9 % Internal Method |
Dry: Water Absorption, Equilibrium(50% RH;23 °C) 1.7 % ISO 62 |
Mechanical Nominal Value Test Method |
Dry: Tensile Modulus 1600 MPa ISO 527-1 |
Condition: Tensile Modulus 900 MPa ISO 527-1 |
Dry: Tensile Stress 45.0 MPa ISO 527-2 |
Condition: Tensile Stress 38.0 MPa ISO 527-2 |
Dry: Tensile Strain, Break 40 % ISO 527-2 |
Condition: Tensile Strain, Break > 50 % ISO 527-2 |
Dry: Flexural Modulus 1600 MPa ISO 178 |
Condition: Flexural Modulus 1050 MPa ISO 178 |
Dry: Flexural Stress 60.0 MPa ISO 178 |
Condition: Flexural Stress 50.0 MPa ISO 178 |
Dry: Charpy Notched Impact Strength ISO 179 |
-40 °C 22 kJ/m² |
23 °C 90 kJ/m² |
Condition: Charpy Notched Impact Strength ISO 179 |
-40 °C 20 kJ/m² |
23 °C 120 kJ/m² |
Thermal |
Nominal Value |
Test Method |
Dry: Deflection Temperature Under Load, Unannealed |
|
|
0.45 MPa |
135 °C |
ISO 75-2/B |
1.8 MPa |
65.0 °C |
ISO 75-2/A |
Dry: Melting Temperature, DSC |
263 °C |
ISO 3146 |
Dry: Flame Rating |
HB |
UL 94 |
Electrical |
Nominal Value |
Test Method |
Dry: Volume Resistivity |
1.0e+15 ohms ·cm |
IEC 60093 |
Condition: Volume resistivity |
1.0E+13 ohms ·cm |
IEC 60093 |
Dry: Electric Strength(2 mm) |
30 kV/mm |
IEC 60243-1 |
Condition: Electric Strength(2 mm) |
36 kV/mm |
IEC 60243-1 |
Processing |
|
Nominal Value |
Drying Temperature<Injection> |
|
80 °C |
Drying Time<Injection> |
|
4.0 hr |
Suggested Max Moisture<Injection> |
|
0.20 % |
Rear Temperature<Injection> |
|
270 - 275 °C |
Middle Temperature<injection> |
|
280 - 285 °C |
Front Temperature<Injection> |
|
285 - 290 °C |
Mold Temperature<Injection> |
|
60 - 90 °C |
Injection Pressure<Injection> |
|
35.0 - 125 MPa |
Injection Rate<Injection> |
|
Moderate - Fast |
Back Pressure<Injection> |
|
0.138 - 0.345 MPa |
Screw Speed <Injection> |
|
80 - 200 rpm |